Mark Levinson 390S Owner's Manual download pdf (Page 31)

• stop/dwr ()

Press to stop play. The same button will operate the drawer

if stopping the disc has no relevance (e.g., if it is already

stopped, or if there is no disc inside the Nº390S).

• pause ()

Press to pause play in the current location. If left in pause

mode for more than two minutes, the Nº390S will enter

extended pause mode, shutting down both the laser and

the drive motors to enhance longevity and reliability.

Upon pressing pause a second time, the disc will spin up

and begin playing from the location where it had been

paused.

3. A/B repeat button

The Nº390S may be set to repeat any contiguous segment of a

disc. Press once to establish a beginning point (point A) for an

endless playback loop. The display will flash the letter B to

indicate that it is ready to accept your designated ending

point (point B). (Note that A must precede B on the disc.)

Once this has been done, the Nº390S will repeat the segment

of the disc between points A and B until you press stop or A-B

again.

4. mode buttons

Using these three buttons, either of two Nº390S functions can

be controlled from the remote control:

• PROGRAM (for creating custom play lists)

• TIMES (for selecting a time indication)

Either of these modes may be accessed by repeatedly pressing

the mode button, thereby toggling back and forth between

the options.

Once a particular mode is chosen, pressing the mode + and

mode – buttons “increases” or “decreases” that particular

function. For example, mode + would either: add a track to a

play list; or advance to the next time indication.

Along with mode + and mode –, the mode button is also used

to change the option settings. (See Special Functions.)

For detailed information on programming the Nº390S, see

Programming the Nº390S later in this manual.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

No comments

Mark Levinson 390S Owner's Manual Page 31