Mark Levinson No535H User Manual download pdf (Page 10)

Mark Levinson

Front Panel

The front panel contains one LED and one Standby button –

as shown.

Standby Button

Places the ampliﬁer into Standby mode. Pressing the button while

the ampliﬁer is in Standby mode turns on the ampliﬁer.

Standby mode powers only the low-voltage power supply, control,

and communication circuits.

Status LED

Indicates the operating state of the ampliﬁer and provides basic

diagnostic information if a fault condition occurs. The table below

identiﬁes the basic behavior of the Status LED.

LED Behavior Description

Fully lit Indicates that the ampliﬁer is powered on.

Slowly blinking Indicates that the ampliﬁer is in Standby mode.

Not lit Indicates that the ampliﬁer is powered off.

Refertothe“Troubleshooting”sectioninthebackofthemanual

for a description of the Status LED behavior when a fault is

detected.

standby

Status LED

Standby

Button

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Mark Levinson No535H User Manual Page 10