Mark Levinson No535H User Manual download pdf (Page 15)

Nº500H Series Power Ampliﬁer

The PC-compatible computer used to connect to the Nº500H series

must have the following software installed:

• Windows

2000 or Windows XP

• Webbrowser(Microsoft

InternetExplorer

6.0 or higher

preferred)

If DHCP is not active, the computer must be set up with a Static IP

address. Refer to the “Setting Up the Computer” procedure found later

in this section for instructions.

The Nº500H series can be connected to the computer in two

ways – through a router or directly to the computer. Before

connecting the cables, ensure that the computer and the ampliﬁer

are powered down.

To Connect Using a Router:

1. Connect a network cable from the router to the Ethernet port

on the rear panel of the ampliﬁer.

2. Attach a second network cable from the router to the Ethernet

port of the computer.

To Connect Without a Router:

Use a network crossover cable to connect the ampliﬁer directly

to the computer. Different from a standard network cable, the

crossover cable is designed to connect network access ports directly

together without a hub, router, or switch.

Connect the crossover cable from the Ethernet port on the rear

panel of the ampliﬁer to the Ethernet port of the computer.

Computer

Requirements

Note

Connecting the Cables

Router

Ampliﬁer

Crossover

Cable

Computer

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Mark Levinson No535H User Manual Page 15