Mark Levinson 512 Owner's Manual download pdf (Page 28)

Mark Levinson

Initial Setup

The player can be connected using either analog or digital outputs.

Use the appropriate setup procedure below.

Set Up Using Analog

to a Preamplifier

To set up the Nº512 using the analog audio outputs into a

preamplifier, perform the following steps. Refer to the cabling

diagram on the left, as needed.

1. Ensure that all components are powered off before making

connections.

2. Connect an audio cable from the Nº512 rear panel Analog

Output Right connector to the Analog Input Right connector on

the preamplifier rear panel. RCA or XLR connectors may be

used.

3. Connect an audio cable from the Nº512 rear panel Analog

Output Left connector to the Analog Input Left connector on

the preamplifier rear panel. RCA or XLR connectors may be

used.

4. Turn on the Nº512 player.

5. Turn on the preamplifier.

6. Turn on the amplifier.

7. Do not proceed until all equipment has gone through its

initialization process and is fully powered on.

8. On the Nº512, press the Drawer button on the front panel to

open the CD drawer.

9. Place a CD or SACD disc in the drawer. Make sure that the disc is

data-side down and seated properly in the drawer.

10. Press the Drawer button to close the drawer.

11. Press the Play button after the disc has loaded.

The first track should now be playing.

If you do not hear audible sound, refer to the “Troubleshooting”

section found later in the manual for suggestions.

512 CD/SACD Player

502 Media Console

Right - XLR

XLR - Left

512 CD/SACD Player

502 Media Console

SINGLE-ENDED ANALOG

BALANCED ANALOG

Left - RCA

Right - RCA

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 49 50

Comments to this Manuals

No comments

Mark Levinson 512 Owner's Manual Page 28

Comments to this Manuals

Related products and manuals for CD players Mark Levinson 512