Mark Levinson 512 Owner's Manual download pdf (Page 30)

Mark Levinson

Set Up Using Digital

Outputs

To set up the Nº512 using the digital audio outputs, perform the

following steps. Refer to the cabling diagram on the left, as needed.

Note When playing a SACD disc, the SACD layer is only available on the

analog audio outputs. However, the CD layer may be played normally

using digital or analog outputs.

1. Ensure that all components are powered off before making

connections.

2. Connect an audio cable from the Nº512 rear panel Digital

Output connector to the Digital Input connector on the

preamplifier rear panel. S/PDIF or AES/EBU connectors may be

used.

3. Turn on the Nº512 player.

4. Turn on the preamplifier.

5. Turn on the amplifier.

6. Do not proceed until all equipment has gone through its

initialization process and is fully powered on.

7. On the Nº512, press the Drawer button on the front panel to

open the CD drawer.

8. Place a CD in the drawer. Make sure that the disc is data-side

down and seated properly in the drawer.

9. Press the Drawer button to close the drawer.

10. Press the Play button after the disc has loaded.

The first track should now be playing.

If you do not hear audible sound, refer to the “Troubleshooting”

section found later in the manual for suggestions.

AES/EBU cable

512 CD/SACD Player

502 Media Console

SPDIF cable

512 CD/SACD Player

502 Media Console

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 49 50

No comments

Mark Levinson 512 Owner's Manual Page 30