Mark Levinson 512 Owner's Manual download pdf (Page 44)

Mark Levinson

Can’t Assign in ML Net

You must assign the slave from the master device. Verify that the

slave you want to assign is listed in the master device list and check

its current state.

If the current state is assigned, you must first unassign it from the

ML Net system. Once a slave is assigned, it will not accept another

assignment until it has first been unassigned. Once the device is

unassigned, you can then reassign it to the desired ML Net system.

For further explanations on assigning slave devices, refer to the

owner’s manual of the master device.

No Response to

Commands in ML Net

1. Verify that the master device and the Nº512 are properly

connected together with a router.

2. Verify that the Nº512 network setup is correct. A PC-compatible

computer is required to access the internal Web page of the

Nº512 to verify its network settings. Refer to the “Network

Setup” section found earlier in this manual for more details.

No Connectivity Via

Ethernet

1. Verify all network cables are properly connected between the

router, switch, or hub and the Nº512. Verify that the computer

network cable is in the correct port.

2. Verify that the Nº512 network setup is correct. A PC-compatible

computer is required to access the internal Web page of the

Nº512 to verify its network settings. Refer to the “Network

Setup” section found earlier in this manual for more details.

3. Verify the age of the router, switch, or hub. If the router, switch,

or hub is more than ten years old, a communication issue with

the Nº512 may exist. Power cycle the Nº512 and use a newer

router, switch, or hub between the network and the Nº512.

Router Can’t Find the

Device Name

If you can’t connect to the internal web page through the device,

then you’ll need to find the device name through the router. The

status page of most routers identify the device names of all located

devices. In some cases, the device name may not be listed but the IP

address that’s assigned to the device is noted. Put this assigned IP

address into the browser address (URL) line and the internal web

page for the device should load.

If you are using ML Net, you can also use the Nº502 to determine

the name of each connected device. Refer to the ML Net section of

the Nº502 Owner’s Manual for further details.

If All Else Fails...

1. Power cycle the Nº512, waiting at least 10 seconds between

powering the Nº512 off and on.

2. Contact an authorized Mark Levinson dealer.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50

Comments to this Manuals

No comments

Mark Levinson 512 Owner's Manual Page 44

Comments to this Manuals

Related products and manuals for CD players Mark Levinson 512